Ctcss Scan; Dcs Scan; High/Mid/Low Power Setting; Offset Direction And Offset Frequency Setup - Alinco DR-CS25 Instruction Manual

The standard set of 50 different CTCSS tones are available. DCS
encode/decode cannot be separated. The list of selectable tones and
codes is shown on Appendix at the end of this manual.

CTCSS SCAN

While receiving CTCSS signal, press
to select or TSQ then hold
starts scanning. Once finding a matching
CTCSS tone, a voice will be heard and
resumes scanning after 15 seconds.
Press any key except and
PWR

DCS SCAN

While receiving DCS signal, press
key until starts scanning. Once finding a
P3
matching DCS code, a voice will be heard and
resumes scanning after 15 seconds.
Press any key except and
PWR

HIGH/MID/LOW Power SETTING

Press key to display icon, then press
FUNC
key to switch between high/Mid/low
P4
power.
None: Transmits in high power 50W
: Transmits in middle power 20W
: Transmits in low power 10W
key
P3
key until
P3
key to exit.
FUNC
key to select DCS then hold
P3
key to exit.
FUNC
KEY OPERATIONS

Offset Direction and offset frequency setup

Repeater receives a signal(UP-LINK) on one frequency and re-transmits
on another frequency(DOWN-LINK). The difference between these two
frequencies is called the offset frequency. If the UP-LINK frequency is
higher than DOWN-LINK frequency, the direction is positive, If it is lower,
the shift direction is negative.
This operation is possible also in the memory mode but
temporaly. Changing frequencies or turning off the radio will reset
the setting.
1. Press and hold key for over 2
P2
seconds, LCD displays offset direction
and offset frequency.
2.
Repeatedly press key to select
P2
positive offset or negative offset.
3. When LCD displays "
means transmitting frequency higher than receiving frequency.
4.
When LCD displays "
means transmitting frequency lower than receiving frequency.
5.
Mic's [ /
accordance with the step setting.
6.
Press any key except
FUNC
In memory mode, this operation can be temporarily available.
" icon, it indicates positive offset, which
" icon, it indicates negative offset, which
] key to change offset frequency in
and key to set and finish setting.
P2
5
13