Appendix Ii -Installing Cutter - Avery Dennison AP 2.4 User Manual

19. Click the top cover back to the middle cover.
20. Insert the sensor connector into its receptacle on the main logic
board of the base housing.
21. Click the middle cover back to the base housing. First click in the
front part then the rear.
22. Secure the two screws at the bottom of the base housing.
H.Cover
4 mmGap
Middle Cover
65
Appendix II - Installing the Cutter
1. Turn off the printer power, unplug the power cable and Centronics /
Serial cable.
2. Remove the top cover.
3. Remove two screws at base housing.
66