Adjusting The Parking Brake - E-TON ATV6A 90 Service Manual

ADJUSTING THE PARKING BRAKE

3 - 23
ADJUSTING THE PARKING BRAKE
1. Check:
• parking brake cable end length
Out of specification
Parking brake cable end length
53.0 ~ 57.0 mm (2.09 ~ 2.24 in)
2. Adjust:
• parking brake cable end length
a. Loosen the locknut
.
b. Loosen the locknut
c. Turn the adjusting nut
until the specified brake cable end
length is obtained.
d. Tighten the locknut
e. Slowly turn the adjusting bolt clockwise until
resistance is felt.
f. Turn it 1/8 counterclockwise.
g. Tighten the locknut
WARNING
After this adjustment is performed, lift the
rear wheels off the ground by placing a
block under the engine, and spin the rear
wheels to ensure there is no brake drag. If
any brake drag is noticed perform the
above steps again.
CHK
ADJ
Adjust.
and adjusting bolt
.
in direction
.
.
16 Nm (1.6 m•kg, 11 ft•lb)
or