Installing The Rear Brake Master Cylinder; Installing The Front Brake Lever Assembly - E-TON ATV6A 90 Service Manual

4
5
STEERING SYSTEM
INSTALLING THE REAR BRAKE MASTER
CYLINDER
1. Install:
• handlebar switch
• handlebar grip
• brake master cylinder
TIP
• Installing the rear brake master cylinder, make
sure the handlebar switch
, and brake master cylinder
2
positions shown in the illustration.
•
Install the brake master cylinder, please align
the
master cylinder holder
The "UP" mark on the brake master cylinder
•
bracket should face up.
•
65 ~ 66 mm (2.56 ~ 2.60 in)
INSTALLING THE FRONT BRAKE LEVER
ASSEMBLY
1. Install:
• front brake lever assembly
• handlebar grip
TIP
• Install the front brake lever assembly, please
align the
front brake lever assembly
• Installing the front brake lever assembly, make
sure the clearance the front brake lever
assembly
2. Adjust:
• front brake
Refer to " ADJUSTING THE FRONT BRAKE"
4
in chapter 3.
6 - 32
punch mark and
4
5
Brake master cylinder bracket
14 Nm (1.4 m•kg, 10.1 ft•lb)
punch mark
and handlebar grip
3
CHAS
, handlebar grip
1
are in the
3
the gap at brake
.
and the gap at
1
.
2
.
4