Speckled Stone Installation - Montigo 30FID Installation & Maintenance Manual

Speckled Stone Installation

If your fireplace has already been in operation, disconnect the gas
and electrical supply, remove the door and safety barrier.
The driftwood log and speckled stone option is a beautiful way to
dress up your new fireplace insert. Installation of the stones and
logs need to be down in a precise way so that the performance of
your appliance is not altered. Follow these instructions for years
of trouble free operation.
1). You will have 6 bags of speckled stones with your package.
Figure 7 Sec.9
2). Empty the bags of stones into a box and GENTLY mix them up.
Figure 8 Sec.9
3). Place a row of stones front and back of the burner, below the
burner lip.
Figure 10 Sec.9
XG0513-092314
Installation
4). Fill one layer of stones over the remaining screen/burner area.
Figure 9 Sec.9
5). Now carefully place 2 rows of stones along the burner rims so
that 1/2 of the stone is sitting on the stones below and 1/2 of the
stone is resting on the lip of the burner alternating sides.
Figure 11 Sec.9
6). WARNING: A close up picture of the pilot area shows that NO
stones are placed over the pilot assembly or directly in front of
where the pilot flame carries over to the burner. Any exception to
this may result in unfavourable lighting of your appliance, or the
durability of the pilot and/or burner.
Figure 12 Sec.9
I-Series Indoor Gas Fireplace
Page 35