Montigo 30FID Installation & Maintenance Manual page 5

I-Series Indoor Gas Fireplace
Installation
Introduction
Introduction
Rating label sample: Natural Gas Sample Shown
Before You Begin
IMPORTANT MESSAGE: SAVE THESE INSTRUCTIONS
The I-Series insert fireplaces must be installed in accordance
with these Instructions. Carefully read all the instructions in
this manual first. Consult the Local Gas Branch to determine
the need for a permit prior to starting the installation. It is
the responsibility of the installer to ensure this fireplace is
installed in compliance with the manufacturers instructions
and all applicable codes.
Installations into a Solid Fuel Burner Fireplace or a Factory
Built Fireplace
This gas appliance has been tested and approved for installation
into any approved masonry or factory built solid fuel fireplace,
in which this gas insert will fit. In the event that the vertical
height of the factory built fireplace is to low and that the removal
of some components such as the flue baffle, flue damper or
surround panels will facilitate the installation of the gas insert,
such components can be removed on the condition that:
1). The removal of such components in no way compromises
the structural integrity of the unit.
2). A Sticker, supplied by the installer, showing this information
is prominently affixed to the firebox.
Figure 1 Sec.1
Rating label location
Page 5
XG0513-092314