Fan Speed Control - Montigo 30FID Installation & Maintenance Manual

Disabling Thermostat
Some jurisdictions and bedroom installations require the
thermostat to be disabled.
1. Partially take out one battery, see figure 35.
2. Insert the battery while holding down the thermostat button.
The remote screen will display 'Clr' while the button is held
down. See figure 35a.
3. To enable thermostat repeat steps 1-2. The remote screen
will display 'set' while the thermostat button is held down.
Figure 18 Sec.10
Figure 19 Sec.10
XG0513-092314
Operation

Fan Speed Control

The fireplace is equipped with hot air circulating fans. The
speed of the fans can be controlled by the Proflame 2 system.
The fan speed can be adjusted through six (6) speeds. To
activate this function use the Mode Key, see figure 25, to index
to the fan control icon, see figure 36. Use the Up/Down Arrow
Keys, see figure 25, to turn on, off, or adjust the fan speed,
see figure 36. A single "beep" will confirm reception of the
..
command.
.
Figure 16 Sec.10
Accent Light Control
The fireplace is equipped with variable accent lights. The
accent light function controls the Accent Lights. To activate
this function use the Mode Key, see figure 25, to index to the
accent light icon, see figure 37.
Pressing the Up Arrow Key will turn the light on at the lowest
setting. Continue pressing up to get brighter. Pressing the
Down Arrow Key will turn the lights down until you get to the
off position. A single beep will confirm the reception of the
command.
Figure 17 Sec.10
I-Series Indoor Gas Fireplace
Fan Speed Control
Light Control
Page 45