Table of Contents
Advertisement
Dongle Installation
To install the Proflame Connect kit it is necessary to turn off the gas
appliance and to disconnect the power supply, wait for the unit to
fully cool.
To the install the dongle:
1.
Unless a compatible board is already installed, remove the old IFC
and replace it with the compatible IFC, (The dongle compatible
IFC boards are distinguished by their green schematic on the
front).
2.
Connect the WiFi dongle to the IFC with the provided cable through
X0A connector.
3.
The dongle can be safely placed on the bottom of the fireplace,
take care to place it out of the way of components such as fans,
and the valve.
RED LED
GREEN LED
Blinking
Blinking
Blinking
OFF
Blinking
OFF
ON
ON
Blinking
Blinking
OFF
ON
Blinking
Blinking
App Installation
Download the Proflame Connect app from Google Play or the Apple
App Store.
Make sure your mobile device is connected to the WiFi network
the WiFi Dongle will use prior to configuration.
XG0681 - 090222
LED TIMING
Synchronized, period of 0,5 sec
Period of 0,5 sec
Period of 1 sec
Alternately, period of 1 sec
Together, period of 0,1 sec
MEANING
Error in flash memory
Error in IFC reading
Error in IFC writing
Working in AP mode
Connecting to the local WiFi network
Connected and working normally
OTA update (optional)
General
To the reset the dongle:
1.
Press and hold the reset
button until the green
and red LED's are lit (5-10
seconds). The Dongle is
now in AP mode.
3
Advertisement
Table of Contents
