Accent Light Replacement - Montigo 30FID Installation & Maintenance Manual

I-series indoor residential fireplace insert
Table of Contents

Advertisement

Accent Light Replacement

Replacement of the fireplace accent lights can be performed
with a few simple steps. The accent lights are located beneath
the burner. We recommend that if you need to replace one
light, that you replace them all at the same time. Another
option would be to replace them at the same time as your
annual service.
1). Disconnect the electrical and gas supply to the unit.
2). Remove the door / safety barrier from the unit.
3). Remove the burner assembly.
4). There are 5 light bulbs in this appliance. They are removed by
pulled them straight up out of their receptacles. New bulbs can be
bought at most national hardware stores or through your Montigo
dealer. See specs page for information on bulbs. If you supply your
own bulbs, do not use greater than 20 watt bulbs.
Figure 35 Sec.10
5). When installing the new bulbs, try to not contaminate the bulb with
your hands. Using gloves or some type of paper during installation
will help to prolong the life of the bulb.
Figure 37b.
XG0514-092314
Maintenance
Fan / Blower Replacement
The Fans or Blowers supplied with your appliance are the best
quality available. These Fans should provide years and years of
trouble free service. Should one of these fail, or start to make a
bearing noise, they can be replaced. There are 2 blowers in this
appliance, one which has the motor on the right side and the
other on the left side.
** The Gas Supply may need to be disconnected from the
Appliance. If this is the case, a license gas fitter will need to
provide this service. **
Figure 37 Sec.10
1). Disconnect Electrical Power. Always disconnect the power
when servicing any appliance.
2). Remove Front and Rear Faceplate. See the section on
Faceplate installation for details.
3). Remove the Flue Collar Slide Plate. See the section on Vent
Connection for details.
4). Remove the Fireplace from the cavity.
5). Remove all screws necessary to remove the Outer Shell Back.
Figure 36 Sec.10
I-Series Indoor Gas Fireplace
Page 51

Advertisement

Table of Contents
loading

This manual is also suitable for:

34fid - linear30fid-linear

Table of Contents