Introduction - Montigo 30FID Installation & Maintenance Manual

I-Series Indoor Gas Fireplace

Introduction

Congratulations on your purchase of a Montigo Fireplace.
With over 30 years of experience, Montigo is committed to providing
you with a gas fireplace that is not only a beautiful addition to your
space, but that is also designed and manufactured to the highest
safety, reliability and engineering standards.
We strongly encourage you to read and carefully follow the instructions
laid out in this Installation, Operation and Maintenance Manual
and retain it for your future reference. Pay special attention to all
cautions, warnings, and notices throughout this manual intended
to ensure your safety.
This manual covers installation, operation and maintenance. Lighting,
operation and care of this fireplace can be easily performed by the
homeowner. All installation and service work should be performed
by a qualified or licensed installer, plumber or gas fitter as certified
by the state, province, region or governing body where the fireplace
is being installed.
This installation, operation and maintenance manual is applicable
to the models described below. Refer to your rating plate to verify
included options.
Input Rating
Gas Supply Pressure
Manifold Pressure
High
Low
Orifice Size (DMS)
Pilot Orifice Size (No.)
Air Shutter Min Settings
Electrical Requirement
Vent Size
Minimum Vent Length
Maximum Vent Length
Efficiency AFUE Method
Efficiency P.4 Method
Clearances
Mantel
Hearth
Side Wall
Control Type
Light Bulb Specification
Fuse Specification
Fan Amperage
Certification(s)
Page 4
Introduction Introduction
30FIDN-L-F [NG] 30FIDL-L-F [LP]
24,000 BTU 23,000 BTU
7" WC 11" WC
3.5" 10"
2.2" 6.4"
41 54
62 35
Fully Closed 3/16"
115 VAC, 60Hz 115 VAC, 60Hz
3" 3"
10' 10'
36' 36'
71.27% 73.26%
77.60% 79.00%
16" 16"
0" 0"
7 7/8" 7 7/8"
SIT Proflame 2 SIT Proflame 2
20W, G6.35, Qty 5 20W, G6.35, Qty 5
3.15Amps 3.15Amps
1.6Amps 1.6Amps
Ansi Z21.88-2014 / CSA 2.33-2014 VENTED GAS FIREPLACE HEATERS
CGA 2.17-M91 [R2009] GAS FIRED APPLIANCES FOR HIGH ALTITUDES
CSA P.4.1-09 [R2014] Fireplace Efficiency
Warranty and Installation Information: (See Appendix B)
The Montigo warranty will be voided by, and Montigo disclaims any
responsibility for, the following actions:
► Modification of the fireplace and/or components including
Direct-Vent assembly or glass doors.
► Use of any component part not manufactured or approved
by Montigo in combination with this Montigo fireplace system.
► Installation other than as instructed in this manual.
Consult your local Gas Inspection Branch on installation requirements
for factory-built gas fireplaces. Installation & repairs should be done
by a qualified contractor.
This appliance is equipped for altitudes from 0 - 4500 feet [0
-1370 m]. For higher altitudes contact your Montigo dealer.
Aluminum / Stainless Flex
XG0513-092314