Faceplate Installation; Standard Faceplate Offset Installation - Montigo 30FID Installation & Maintenance Manual

I-Series Indoor Gas Fireplace

Faceplate Installation

Standard Faceplate Offset Installation

When the standard faceplate is used the install width of the
fireplace is 30 inches. If your install is smaller than 30 inches,
you can use the offset kit, which will allow you to decrease
the install size to 28 inches. This can only be done with the
standard faceplate kit. You must install the offset kit on the
standard faceplate before installing it on the appliance.
Figure 1 Sec.7 Standard Faceplate Offset Kit
Contents
1). Unpack the standard faceplate kit. Take the rear faceplate
and cut 0.325 inches away from the wire pass-through hole at
the bottom right hand corner.
Figure 2 Sec.7 Cutting away excess material
Page 24
Installation
2). Take the offset faceplate and peel the red protective plastic off
of the self-adhesive tape.
Figure 3 Sec.7 Peeling self-adhesive tape
3). Place the rear panel from the standard faceplate over top of
the offset trim. Press down on the adhesive to guarantee good
adhesion.
Figure 4 Sec.7
Figure 5 Sec.7 Offset Trim Installed on Rear Panel of Standard Faceplate
4). Continue to standard faceplate installation section for
remainder of installation.
XG0513-092314