Modify A Segment Of The Network; Remove A Segment From The Network - 8e6 Technologies R3000IR User Manual

G A
LOBAL DMINISTRATOR
224
S C 2: G
ECTION HAPTER
TIP: Use the Calculator to calculate IP ranges without any over-
laps. Enter the IP address, select the Netmask, and then click
Calculate to display results in the Min Host and Max Host fields.
Click Close to exit.
NOTE: Click Cancel to be given the option to return to the main
Range to Detect Settings window without saving your settings.
2. Click Apply to accept your entries and to return to the
main Range to Detect Settings window.

Modify a Segment of the Network

To modify a segment:
1. In the main Range to Detect Settings window (see Fig.
2:2-3), select the segment from the Current Ranges list
box.
2. Click Modify to go to the second page (see Fig. 2:2-4).
3. Click one of the following buttons to select the procedure
for modifying the segment:
• Start the Setup Wizard - clicking this button takes you
to Step 6 of the Range to Detect Setup Wizard (see
Fig. 2:2-10). Follow the instructions in the Range to
Detect Setup Wizard sub-section for Step 6.
• Advanced Settings - clicking this button takes you to
the Range to Detect Advanced Settings window (see
Fig. 2:2-11). Follow the instructions in the Range to
Detect Advanced Settings sub-section.

Remove a Segment from the Network

To remove a segment:
1. In the main Range to Detect Settings window (see Fig.
2:2-3), select the segment from the Current Ranges list
box.
2. Click Remove.
ROUP SCREEN
8 6 T , R3000 E
E ECHNOLOGIES
F U G
NTERPRISE ILTER SER UIDE