Router (Ac Model) - Juniper E-Series Installation And User Manual

ERX-310 router (AC model)
1
Insert the power cord into the AC power IEC receptacle (see
Figure 6-6).
2
Insert the other end of the power cord into an appropriate AC power
source.
Note: To provide redundancy, Power A and Power B leads should not terminate at
the same power source.
3
Repeat steps 1–2 for the other power input module, if needed.
Figure 6-6 ERX-310 router, rear view (AC model)
Cabling the E-Series Router for Power
E-Series Routers
6-13