Replacing And Managing Modules Using The Software; Hot-Swapping Modules; Protecting Modules And Slots - Juniper E-Series Installation And User Manual

Replacing and Managing Modules Using the Software

Hot-Swapping Modules

Protecting Modules and Slots

For information about software procedures associated with replacing and
managing modules, see
Chapter 5, Managing Line Modules and SRP
All E-series routers support hot-swapping of modules. Hot-swapping
allows you to add or remove a module without powering down the
system.
Each E-series chassis has an ESD (electrostatic discharge) grounding jack.
See Table 5-1 for locations. To prevent damage from electrostatic
discharge, connect an antistatic wrist strap to the jack when handling
components.
Figure 5-4 Connecting the wrist strap to the ERX-310 router (rear)
Table 5-1 Grounding jack locations
E-Series Router Location
ERX-14xx model Front: inside front bezel in lower-left corner
Rear: upper-right corner
ERX-7xx model Rear: lower-right corner
ERX-310 router Front: lower-left corner
Rear: lower-right corner
E-Series System Basics Configuration Guide,
Overview
E-Series Routers
Modules.
5-5