Replacing An Nvs Card - Juniper E-Series Installation And User Manual

Replacing an NVS Card

To replace an NVS card on an SRP module:
1
Obtain an antistatic container for the NVS card you will remove (see
Storing Modules and
2
With a small flathead screwdriver, remove the faceplate from the
NVS card slot on the SRP module (see
3
Use the screwdriver to depress the button next to the NVS card (see
Figure 9-1).
This action releases the NVS card.
Figure 9-1 NVS card slot on SRP module
4
Remove the NVS card and place it in the antistatic container.
5
Insert the new NVS card into the slot.
6
Push the new NVS card as far as you can in the slot.
When you push the card far enough, it will click into place.
7
Replace the faceplate on the NVS card slot.
Upgrading NVS Cards on SRP Modules
Components, earlier in this chapter).
Figure
E-Series Routers
9-1).
9-5