11
SERVICE WORK ON THE CHASSIS
11.6
Positioning the fork protection
11.7
Removing the fork legs
11.8
Installing the fork legs
–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the brake line. Position the clamp and mount and tighten screws
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
800197-10
x
Preparatory work
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
Main work
–
Remove screws
–
Remove screws
–
Allow the brake caliper and brake line to hang tension-free to the side.
800191-10
–
Unscrew screws
–
Unscrew screws
101731-10
x
Main work
–
Position the fork legs.
Info
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
Position bleeder screws
101672-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
101731-11
x
(
p. 73)
and take off the clamp.
1
and take off the brake caliper.
2
. Take out the left fork leg.
3
. Take out the right fork leg.
4
toward the front.
1
.
2
.
3
M6
10 Nm (7.4 lbf ft)
M6
10 Nm (7.4 lbf ft)
p. 40)
M8
17 Nm
(12.5 lbf ft)
M8
12 Nm (8.9 lbf ft)
42
.
1
.
2