10
TUNING THE CHASSIS
10.15
Adjusting the handlebar position
Warning
Danger of accidents Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
x
–
Remove screws
to one side.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
–
Remove screws
–
Place the handlebar support in the required position. Mount and tighten screws
B00375-10
Guideline
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount screws
Guideline
Screw, handlebar clamp
. Remove the handlebar clamp. Remove the handlebar and lay it
1
. Remove the handlebar support.
2
M10
40 Nm
Loctite
(29.5 lbf ft)
and tighten evenly.
1
M8
20 Nm
(14.8 lbf ft)
39
.
2
®
243™