Service Work (As Additional Order); All Xc Models; Service Schedule - KTM 125 SX EU Owner's Manual

9

SERVICE SCHEDULE

9.1.2

Service work (as additional order)

Change the front brake fluid.
Change the rear brake fluid.
Change the hydraulic clutch fluid.
Grease the steering head bearing.
Check/set the carburetor components.
Service the shock absorber.
Change the connecting rod, conrod bearing and crank pin.
Check the transmission and shift mechanism.
Change all engine bearings.
S20N: Once after 20 operating hours - corresponds to about 140 liters of fuel (37 US gal)
S40A: Every 40 operating hours - corresponds to about 280 liters of fuel (74 US gal)
J1A: Annually
9.2

All XC models

9.2.1 Service schedule
Check and charge the battery.
Change the gear oil.
x
Check the front brake linings. (
Check the rear brake linings. (
Check the brake discs. (
Check the brake lines for damage and leakage.
Check the rear brake fluid level. (
Check the free travel of the foot brake lever. (
Check the frame and swingarm.
Check the swingarm bearing.
Check the shock absorber linkage.
Conduct a minor fork service.
Check the tire condition. (
Check the tire air pressure. (
Check the wheel bearing for play.
Check the wheel hub.
x
Check the rim run-out.
x
Check the spoke tension. (
Check the chain, rear sprocket, engine sprocket, and chain guide. (
Check the chain tension. (
Grease all moving parts (e.g., hand lever, chain, ...) and check for smooth operation.
Check/correct the fluid level of the hydraulic clutch. (
Check the front brake fluid level. (
Check the free travel of the hand brake lever. (
Check the play of the steering head bearing. (
Change the spark plug and spark plug connector.
Check the intake diaphragm.
Check the exhaust control for functioning and smooth operation.
Check the clutch.
x
Check all hoses (e. g. fuel, cooling, bleeding, drainage) and sleeves for cracking, leaks, and incorrect routing.
Check the antifreeze and coolant level. (
Check the cables for damage and routing without sharp bends.
Check that the throttle cables are undamaged, routed without sharp bends and set correctly.
x
x
( p. 63)
x
( p. 47)
x
x
x
x
x
(250/300 XC)
x
p. 67)
p. 71)
p. 65)
p. 70)
p. 69)
x
x
x
x
p. 75)
p. 76)
x
p. 76)
p. 56)
p. 66)
p. 65)
p. 46)
x
x
p. 81)
x
p. 57)
p. 62)
x
x
S20N
•
x
x
28
S40A J1A
•
•
•
•
• •
•
•
•
•
S20A S40A
• •
• •
• •
• •
• •
• •
• •
• •
• •
•
• •
• •
• •
• •
• •
• •
• •
• •
• •
• •
• •
• •
• •
• •
• •
• •
• •
•
•
• •
• •
• •
• •