Deactivate External; Transmit Tampering As Burglary - Abus Terxon MX Installation Instructions Manual

129 Deactivate external

To change the settings:
1. On the control unit, enter:
2. The LCD display shows: 129:ExtUnset OFF
3. Via the keypad, select from the following items
and press:
ExtUnset OFF
The user must first enter the entry zone
0
and thereby start the entry time before
he is able to deactivate using the
remote control.
ExtUnset OFF
1
The user can deactivate the alarm
centre without entering the entry zone.
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
131 SIA report mode
To change the settings:
1. On the control unit, enter:
2. The LCD display shows: 131:Mode=Basic
3. Via the keypad, select from the following items
and press:
Mode=Basic
0
See the appendix for a description
Mode=Summary
1
See the appendix for a description
Mode=Intermd
2
See the appendix for a description
Mode=Full
3
See the appendix for a description
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
129
131
77

132 Transmit tampering as burglary

To change the settings:
1. On the control unit, enter:
2. The LCD display shows: 132:TA = BA OFF
3. Via the keypad, select from the following items
and press:
TA = BA OFF
0
The alarm centre transmits all SIA
reports as specified in command 131.
TA = BA ON
During an external alarm, the alarm
1
centre transmits tampering as a
burglary message and contact ID 130
instead of Contact ID 137.
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
133 SIA Reset
To change the settings:
1. On the control unit, enter:
2. The LCD display shows: 133:SIA Rst OFF
3. Via the keypad, select from the following items
and press:
SIA Rst OFF
The alarm centre does not transmit any
0
SIA reset reports (fire, panic, technical,
tamper resets)
SIA Rst ON
1
The alarm centre transmits SIA resets.
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
132
133
UK