First Alarm Reaction; Panic Reset - Abus Terxon MX Installation Instructions Manual

1
UK
Note:
Some events always require you to enter the program
code. These are:
Failure/fault of a control unit
Failure of 12V power supply
Low battery in the alarm centre
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.

034 Panic Reset

Proceed as follows to change the property of the panic
reset:
1. On the control unit, enter:
2. The LCD display shows: 034:PA Cust Rst
3. Via the keypad, select from the following items
and press:
0
1
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
acknowledge the message.
EngReset OFF
If a system error is displayed, you have
to enter the program code to
acknowledge the message.
034
PA Cust Rst
To reset a panic alarm, you only have
to enter a valid user code.
PA Eng Rst
To reset a panic alarm, you have to
enter the user code to deactivate the
alarm and then the program code to
delete the panic alarm.

035 First alarm reaction

Proceed as follows to change the property of the first
alarm reaction:
1. On the control unit, enter:
2. The LCD display shows: 035:Lock-out ON
3. Via the keypad, select from the following items
and press:
Lock-out ON
When the alarm time expires (alarm
time of the local alarm of the external
0
siren), the alarm centre is reactivated.
The zone that triggered the alarm is no
longer monitored.
Re-arm
When the alarm time expires (alarm
time of the local alarm of the external
1
siren), the alarm centre is reactivated.
The zone that triggered the alarm is
monitored again.
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer mode.
036 Alarm cancellation
Sometimes users trigger a false alarm. To change the
property of the alarm cancellation:
1. On the control unit, enter:
2. The LCD display shows: 036: Abort OFF
3. Via the keypad, select from the following items
and press:
Abort OFF
0
Cancellation by the user is not allowed.
Abort ON
1
Users are allowed to cancel an alarm.
4. Confirm your input. On the control unit, enter:
.
52
035
036