Abus Terxon MX Installation Instructions Manual page 56

045 Entry/exit delay tone volume
To change the property of the entry/exit delay tone
volume:
1. On the control unit, enter:
UK
2. The LCD display shows: 045:EE VOL=5
3. Via the keypad, select from the following items
and press:
0
1-9
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
046 Tamper alarm
To change the property of the tamper alarm for a
deactivated alarm centre:
1. On the control unit, enter:
2. The LCD display shows: 046: Int+RKP
3. Via the keypad, select from the following items
and press:
0
1
2
4. Confirm your input. On the control unit, enter:
.
045
EE VOL=OFF
Entry/exit delay tone off
EE Vol=1 / 2 / 3 / 4 / 5 / 6 / 7 / 8 / 9
Entry/exit delay tone quiet (1) to loud
(9)
046
Internal
Following a tamper alarm when the
alarm centre is deactivated, only the
intern alarm is triggered.
Keypad
Following a tamper alarm when the
alarm centre is deactivated, the control
unit is triggered.
Int+RKP
Following a tamper alarm when the
alarm centre is deactivated, the control
unit and the internal alarm are
triggered.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
047 Partition A alarm Reaction
To change this feature, proceed as follows:
1. On the control unit, enter:
2. The LCD display shows: 047:A=Keypad
3. Via the keypad, select from the following items
and press:
A = Keypad
0
Control unit alarm
A = Local
1
Control unit + loudspeaker
A = Full
2
Control unit + loudspeaker + dial
module
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
048 Control unit lock
If you want to allow the user to deactivate the system
using a proximity chip key then the control unit must be
locked (UF, FE, MD, code entry, false alarm cancellation,
inactive on alarm once more active). To change the
property of the control unit lock, proceed as follows:
1. On the control unit, enter:
2. The LCD display shows: 048: Code Lk OFF
3. Via the keypad, select from the following items
and press:
Code Lk OFF
0
The system allows all users to use all
control units during the entry.
Code Lk ON
1
During entry, the system locks access
to the control units from all users.
56
047
048