Disassembly Procedures
!
CAUTION: When reassembling Front Panel route the
Light Socket wire harness behind the Door Switch.
This prevents the harness from contacting the
rotating drum during dryer operation.
14.Service Front Drum Seal and Glides as needed.
SEAL
20
WARNING
GLIDE
16023432 Rev. 0
To avoid risk of electrical shock, personal injury or
death; disconnect power to unit before servicing.
Drive Belt Removal
1. Disconnect power supply to unit.
2. Remove dryer Top Cover.
3. Remove Console.
4. Remove Front Panel.
5. Remove 3 screws attaching Blower Inlet Panel to
cabinet.
6. Lift Inlet Panel from dryer.
7. Remove 3 screws retaining Back Cover to cabinet.
8. Release tension on belt by moving Tension Pulley
toward the Drive Motor.
©2004 Maytag Services