Drive Motor And Idler Assembly - Maytag 111990" Automatic Dryers Service Manual

4. Remove blower housing.
5. When replacing blower housing be
certain the clip retaining ring is
properly replaced into the groove in
the motor shaft.
EXHAUST DUCT PIPE
One end of the exhaust duct pipe is
held to the back of the cabinet by one
screw. It fits over the blower housing
on the opposite end.
the heat source when motor reaches
speed.
The external motor switch is secured to
the motor with two screws.
1. Remove front panel.
2. Remove tumbler front.
3. Remove tumbler.
4. Remove two screws holding switch
to drive motor.
MOTOR
PULLEY
DRIVE MOTOR AND IDLER
ASSEMBLY
Shown is the 2-groove, 60 Hz, 47 rpm
pulley. This identifies the pulley for 60
Hz. operation. 50 Hz. has 3 grooves.
A switching device in a motor used to
change the path of electricity from both
start and run windings to run winding
only. It also completes the circuit to
1. Remove front panel.
2. Remove tumbler front.
3. Remove tumbler.
4. Place hexhead wrench in set screw.
5. Using a hammer or rubber mallet,
stri ke the end of the hexhead
wrench, as shown.
NOTE GROOVES
IDLER
PULLEY
MOTOR
PULLEY &
SET
SCREW
SPACER
IDLER ARM
& SHAFT
I
MOTOR
BASE
MOTOR
CLIPS
<~
MOTOR
-J -
~
/
~
SWITCH
/ ~
.
' .
DRIVE
MOTOR
MOTOR
SWITCH
GROUND
WIRE
~---_I
ED/GD401 1090 SECTION 3. SERVICE PROCEDURES
3·28