Maytag MDE2400AYW - 3.7 cu. Ft. Electric Dryer Installation Instructions Manual
  1. Manuals
  2. Brands
  3. Maytag Manuals
  4. Dryer
  5. MDE2400AYW - 3.7 cu. Ft. Electric Dryer
  6. Installation instructions manual

Maytag MDE2400AYW - 3.7 cu. Ft. Electric Dryer Installation Instructions Manual

Automatic dryer
Hide thumbs Also See for MDE2400AYW - 3.7 cu. Ft. Electric Dryer:
Table of Contents

Advertisement

Quick Links

AUTOMATIC DRYER INSTALLATION INSTRUCTIONS
MISE EN SERVICE SÉCHEUSE AUTOMATIQUE
INSTRUCCIONES DE INSTALACIÓN DE LA SECADORA
AUTOMÁTICA
The installation, including a proper exhaust system,
is the responsibility of the owner.
La responsabilité de la mise en service, y compris le système
d'évacuation qui convient, revient au propriétaire.
Es responsabilidad del propietario la instalación correcta,
incluso la del sistema de escape.
LEAVE THESE INSTRUCTIONS WITH THE OWNER
REMETTRE CES INSTRUCTIONS AU PROPRIÉTAIRE
DEJE ESTAS INSTRUCCIONES CON EL PROPIETARIO
DEJE ESTAS INSTRUCCIONES CON EL PROPIETARIO
2201460
(revised 6/25/04)
1

Advertisement

Table of Contents
loading

Related Manuals for Maytag MDE2400AYW - 3.7 cu. Ft. Electric Dryer

Summary of Contents for Maytag MDE2400AYW - 3.7 cu. Ft. Electric Dryer

  • Page 1 AUTOMATIC DRYER INSTALLATION INSTRUCTIONS MISE EN SERVICE SÉCHEUSE AUTOMATIQUE INSTRUCCIONES DE INSTALACIÓN DE LA SECADORA AUTOMÁTICA The installation, including a proper exhaust system, is the responsibility of the owner. La responsabilité de la mise en service, y compris le système d’évacuation qui convient, revient au propriétaire.

  • Page 2: Cabinet Dimensions

    Tools needed for installation 22001460 Printed in U.S.A.. • Impreso en los Estados Unidos • Stampato negli Stati Uniti (revised 06/23/04) • Cutting knife • Nut drivers • Level • Duct tape • Crescent wrench Proper installation is the responsibility of the owner. HOWEVER, SERVICE CALLS PERFORMED AS A RESULT OF POOR SET-UP, ADJUSTMENT AND CONNECTION ARE THE RESPONSIBILITY OF THE INSTALLER.

  • Page 3: Important To Installer

    IMPORTANT TO INSTALLER Please Read The Following Instructions Carefully Before Starting To Install The Dryer. These Instructions Should Be Retained For Future Reference. REMOVE THE DOOR FROM ALL DISCARDED APPLIANCES SUCH AS DRYERS TO AVOID THE DANGER OF A CHILD SUFFOCATING. LOCATION CONSIDERATIONS The dryer should be located to permit adequate room in front for loading the dryer, and sufficient room behind the dryer for the exhaust system.

  • Page 4: Mobile Home Installation

    MOBILE HOME INSTALLATION The installation of the dryer in mobile homes must conform to the Manufactured Home Construction and Safety Standard Title 24 CFR, Part 32-80 {formerly the Federal standard for Mobile Home Construction and Safety, Title 24, HUD (Part 280), 1975} for the United States,) or CSA Standards Z240 (for Canada).
  • Page 5 • Secure joints with duct tape. Do not use screws. • DO NOT EXHAUST DRYER INTO ANY WALL, CEILING, CRAWL SPACE OR A CONCEALED SPACE OF A BUILDING, GAS VENT, ANY OTHER COMMON DUCT OR CHIMNEY. THIS COULD CREATE A FIRE HAZARD FROM LINT EXPELLED BY THE DRYER.

  • Page 6: Electrical Requirements

    The static pressure in any exhaust system must not exceed 0.48 inches of water column, or be less than 0. This can be measured with the dryer running with a manometer at the point where the exhaust duct connects to the dryer. A no heat setting should be used. The dryer tumbler should be empty and the lint filter clean.

  • Page 7: Electrical Connections

    If a power cord is not used and the electric dryer is to be permanently wired, the dryer must be connected to a grounded metal, permanent wiring system; or an equipment-grounding conductor must be run with the circuit conductors and connected to the equipment-grounding terminal.

  • Page 8: Replacement Parts And Accessories

    REPLACEMENT PARTS AND ACCESSORIES If your dryer requires replacement parts or accessories, contact the dealer from whom you purchased your dryer or Maytag Customer Service, Box 2370, Cleveland, Tennessee 37320- 2370, phone 423-472-3333, for information on the nearest authorized Maytag Parts...
  • Page 9 INSTALLATION Parts and literature are packaged inside of dryer drum. To Install… Move dryer to an appropriate location for installation. Consider installing the dryer before the washer in side-by-side installations, to allow access to gas, electrical and exhaust connections. Lay two of the carton corner posts on the floor. Tip the dryer forward on its front so it will lay across both corner posts.

  • Page 10: Export Models

    3-WIRE SYSTEM CONNECTIONS If the power cord has ring terminals: 1. Place the terminals over the existing nuts on the posts. 2. The neutral (white or center wire on power cord) conductor must always be connected to the center (silver colored) post of the terminal block. 3.

  • Page 11: Final Installation Checklist

    7. Check All Connections: At this time, make sure all gas connections (on gas models), exhaust and electrical connections are complete. Plug dryer in, and check operation by using the check list below. FINAL INSTALLATION CHECK LIST ❏ Dryer is plugged into electrical outlet and is properly grounded. ❏...
  • Page 12 Maytag dryer models manufactured for operation on 60 Hz AC are not designed for use on 50 Hz AC electrical service and conversion of the product from 60 to 50 Hz operation is not recommended.

Table of Contents