Parts Locations And Removal; Computer Panel Assembly Removal; Computer Board Removal; Lint Drawer Removal - Maytag MLG-45 Service Manual

Parts Locations and Removal ________

NOTE: Disconnect power to the machine at all times
before removing or installing any components!

Computer Panel Assembly Removal

Remove the four screws holding the middle trim panel to
the dryer. Lift out on the panel and then pull down on the
computer panel assembly.
Pull the panel towards you, then align the hinge bracket in
the hinge bracket slots.
At this point you can disconnect the connectors that are on
the boards and totally remove the complete panel from the
dryer.
4

Computer Board Removal

Follow instructions for computer panel removal. Disconnect
all connectors connected to the board.
Remove the four hex nuts securing the computer to the
computer panel. Then remove the computer and remove
the Phillips screw securing the computer and computer baord
cover.

Lint Drawer Removal

Unlock the lint drawer (if equipped with a lock) pull out the
lint drawer 3/4 out, under the lint drawer is a rocker type
locking mechanism push up on one end of this rocker type
lock and remove it completely.
Maytag Co. 450386 - 1