Cylinder Light Receptacle; Cylinder Belt; Cylinder Assembly - Maytag Amana NDE2330AYW Service Manual

Disassembly Procedures
!
WARNING

Cylinder Light Receptacle

1. Disconnect power supply to unit.
2. Remove front panel, see "Front Panel" procedure
steps 1 – 4.
3. Disconnect and label wire terminals from light
receptacle.
4. Squeeze plastic tabs together and push light
receptacle out of front bulkhead.
5. Reverse procedure to reassemble.
NOTE: Refer to appropriate wiring diagram when
rewiring switch.

Cylinder Belt

1. Disconnect power supply to unit.
2. Remove front panel, see "Front Panel" procedure
steps 1 – 4.
3. Disengage belt from motor and idler pulleys.
4. Remove front bulkhead, see "Front Bulkhead"
procedure.
5. While supporting cylinder, carefully remove belt from
cylinder.
Belt
6. Reverse procedure to reassemble.
NOTE: Be sure belt is properly installed on motor and
idler pulleys, and is on the correct side of the
idler lever. Belt must be positioned around
cylinder between center and rear baffle screws
with the ribbed surface against the cylinder.
After installing belt, manually rotate cylinder
counterclockwise to check that belt is properly
aligned.
NOTE: When reassembling, be sure seal on exhaust
fan cover makes airtight seal on flange of duct.
If the seal is installed improperly, the airflow
through the exhaust system will be restricted
which can adversely affect dryer performance.
NOTE: Refer to appropriate wiring diagram when
rewiring.
©2004 Maytag Services
Ider pulley
Idler lever
16023020
To avoid risk of electrical shock, personal injury, or
death, disconnect power and shut-off gas supply valve
to unit before servicing.

Cylinder Assembly

1. Disconnect power supply to unit.
2. Remove front panel, see "Front Panel" procedure
steps 1 – 4.
3. Disengage belt from motor and idler pulleys.
4. Remove front bulkhead, see "Front Bulkhead"
procedure.
5. Remove screws securing cabinet top and lift cabinet
top to a vertical position by hinging it on the rear
hold-down hinges.
NOTE: Cabinet top may be raised and hinged on the
rear hold-down hinges, or supported against a
wall behind the dryer.
6. Carefully remove cylinder out through front of dryer.
7. Remove screws securing baffles to cylinder.
Baffle
(includes
three baffles)
8. Reverse procedure to reassemble.
NOTE: When reassembling, be sure seal on exhaust
fan cover makes airtight seal on flange of duct.
If the seal is installed improperly, the airflow
through the exhaust system will be restricted
which can adversely affect dryer performance.
NOTE: Refer to appropriate wiring diagram when
rewiring.
Cylinder
Rear
rib
25