Ice Auger And Crusher Assembly - Frigidaire LGUB2642LF2 Service Manual

Component Teardown
Ice Auger and Crusher Assembly Removal
To remove the ice auger & crusher assembly:
1. Extract the four screws securing the ice container
front to ice container. (See Figure 6-91)
2. Remove E-ring and washer on front of crusher
housing.
3. Extract the two screws securing the control rod to
the bottom of the ice bin container. Remove control
rod from steel plate by pressing in on the ice gate
and rotating the control rod out from under the arm
of the ice gate. Rotate control rod until the crimps
line up with the slot in the steel plate, then slide
control rod out from steel plate. (See Figure 6-92)
4. Rotate steel plate, crusher assembly and auger out
of bucket.
5. Extract the four screws securing crusher housing to
the steel mounting plate. (See Figure 6-93)
6. Slide crusher housing off of the steel plate.
7. The auger nut is a left hand thread round plastic
nut. Remove to gain access to the crusher blades.
Each blade is separated by a spacer. A crusher
hammer is mounted between crusher blades number
two and four. A pin is pressed into the crusher
hammer securing it to the crusher blades. Remove
crusher hammer by removing the crusher blades
from the shaft, then using a 3/16" diameter or
smaller punch, and press out pin. (See Figure 6-94)
8. With crusher blades and spacers removed, remove
the drum and drive bar from the auger.
9. Replace assembly in reverse order.
Steel Plate
Crimp
Remove
Screws
Crusher
Blades
Left Hand
Thread
Nut
Pin
6-32 6-32
Remove
Screws
Figure 6-91.
Hinge
Pins
Figure 6-92.
Remove
Figure 6-93.
Ice Auger
Shaft
Crusher
Hammer
Figure 6-94.
Ice
Gate
Screws