Door Mullion - Frigidaire LGUB2642LF2 Service Manual

Door Mullion and Heater Removal
There is a mullion attached to the right hand food door
that fill the gap between the doors when the right door
is closed. This mullion contains a heater that is used to
control condensation on the mullion.
The heater is supplied as part of the mullion. The
mullion swings flat against the inner door panel of
the right food door. A roller on the top of the mullion
engages in the guide fastened to the top of the food
liner when the right door is opened.
To remove the door mullion:
1. Disconnect power from unit.
2. Open the right food door. Press latch to open
mullion. (See Figure 6-12)
3. Remove the retainer screw located in the center
pivot bracket. (See Figure 6-13)
4. Lift the mullion straight up off the 3 pivot pins.
5. Disconnect the electrical connector located behind
the center pivot bracket and remove the mullion.
6. Resemble in reverse order.
Top Door Hinge Cover Removal
To prepare for removing the doors:
1. Make sure the electrical power cord is unplugged
from the wall outlet.
2. Remove any food from the door shelves and close
the doors.
To remove the top hinge covers:
1. Remove the two (2) screws from the cover over the
top door hinge of the door being removed.
(See Figure 6-14 and Figure 6-15)
2. Lift inside edge of hinge cover and tilt back.
NOTE: DO NOT remove the ground screw from hinge.
Component Teardown
Flipper
Mullion
Hinge
Flipper
Mullion
Rear
Cover
Screw
Ground
Top
Screw
Hinge
6-5
Press Latch
Electrical Connection
Figure 6-12.
Flipper
Mullion
Set
Screw
Figure 6-13.
Mullion
Guide
Thickness
Of A Dime
Figure 6-14.
Front Cover
Screw
Top Hinge
Cover
Hinge
Screws
Two Wire
Cables
Leave
Hinge
With
Door
Figure 6-15.