Ice Maker Air Duct; Ice Maker And Mounting Plate - Frigidaire LGUB2642LF2 Service Manual

Ice Maker Air Duct

Non-Dispenser Models
There is an air duct that mounts to the evaporator cover
and directs air onto the ice maker mold. The air duct
also serves as a cover for the ice maker wire harness
connector. The air duct must be removed to disconnect
the ice maker wire harness.
To remove the ice maker air duct:
1. Disconnect refrigerator from electrical supply.
2. Remove the freezer door.
3. Remove freezer section baskets.
4. Extract screw from air duct. Remove air duct from
unit. (See Figure 6-43)

Ice Maker and Mounting Plate

Non-Dispenser Models
To remove the ice maker:
1. Disconnect refrigerator from electrical supply.
2. Remove the freezer door.
3. Remove freezer section baskets.
4. Remove ice maker air duct.
5. Disconnect ice maker from wire harness connection.
6. Extract the one screw at the front of mounting plate.
(See Figure 6-44)
7. The ice maker will then slide forward to allow the
shoulder screws in the liner to pass through the key-
hole slots in the mounting plate.
8. The mounting plate is removed from the ice maker
by extracting the three screws from the bottom of
the assembly. (See Figure 6-45)
Component Teardown
Screw
Screw
6-15
Figure 6-43.
Screws
Figure 6-44.
Keyhole Slots
Screws
Figure 6-45.