Automatic Ice & Water Dispenser - Frigidaire LGHK2336TF8 Use & Care Manual

AUTOMATIC ICE & WATER DISPENSER
Priming the water supply system
CAUTION
For proper dispenser operation, recom-
mended water supply pressure should fall
between 30 psi and 100 psi. Excessive pres-
sure may cause the system to malfunction.
1 Begin filling the system by pressing and
holding a drinking glass against the water
dispenser
paddle.
2 Keep the
glass
in this
position
until water
comes out
of the dis-
penser. It
may take
about 1½
minutes.
3 Continue
dispensing
water for
about four minutes to flush the system and
plumbing connections of any impurities
(stopping to empty the glass as necessary).
 NOTE
The water dispenser has a built-in device that
shuts off the water flow after three minutes
of continuous use. To reset this shutoff
device, simply release the dispenser paddle.
 NOTE
Dispensed water is not chilled. For colder
water, add ice to cup or container before
dispensing water.
Ice maker operation & care
After the refrigerator is installed properly and
has cooled for several hours, the ice maker can
produce ice within 24 hours. The ice maker will
fill the ice bin from the rear. You must dispense
some ice to force the ice forward in the bin.
This will allow the bin to fill completely.
Dispenser
(varies by model)
Ice Maker and Storage
Bin Capacity
This ice maker should produce 2.5 to 3 pounds
of ice per 24 hours, depending on usage
conditions. Ice is produced at a rate of 10
cubes every 75 to 90 minutes.
How much ice can be stored in
the ice bin?
When completely full, the bin in standard
depth units will hold about 11 pounds of ice
(total weight of ice and bin will be about 15
pounds). The bin in counter depth units will
hold about 8.5 pounds of ice (total weight of
ice and bin will be about 12 pounds).
Turning the ice maker on and off
Ice production is controlled by the ice maker's
On/Off feature on the control panel. Pressing
and holding the On/Off button toggles the ice
maker On/Off.
IMPORTANT
Turning off the ice maker simply disables
ice making. You will still be able to dispense
existing ice, and you will still be able to
dispense water.
 NOTE
The ice maker also has a built-in plastic
signal arm that automatically stops ice
production when the ice bin is full. This
signal arm should not be used to manually
stop the ice maker.
21