Table of Contents
Advertisement
Ice Maker (Flex Tray Fresh Food Compartment)
Flow Chart # 3 Hollow Ice Cubes in Bucket
Repair the
dispenser door
closer assembly or
Replace Ice door
seal
No
Check the ice door
on the dispenser, is it
closing all the way
and is the seal in
good shape
Yes
Is the house
water pressure
between 30 and
100 PSI
No
Advise Home
owner to correct
pressure problem
Hollow Ice Cubes
in Bucket
Is the insulation
block and retainer in
place on the bottom
of the ice tray?
Yes
Is the outer
housing over the ice
maker correctly
installed so that the
cover is sealed to
the food
liner
Yes
Enter Ice maker
Service Mode
Test 52C will
start automatically when
Entering Service Mode.
Does thermistor check
Good
Yes
Run test 63 C
Are all the ice cubes falling
out of the tce tray
Yes
Run test 55 C
Are you getting the correct
Yes
fill time based on the Cube
Size setting (See page
4-51),
Replace insulation
No
block and retainer
No
Reinstall housing
Check for open connections,
pin backouts, etc. at the ice maker plug
and the lower control board connector J 6,
terminals 4 and 8 and all intermediate
connectons. Are there any bad
connections?
No
Is there a clicking
sound or can you see the
Replace ice maker
No
tray vibrating when it is
going through the
twisting motion.
Yes
Replace the ice
maker
No
Replace the lower
control board
4-8
Replace the ice
No
maker.
Repair the
Yes
connectons and
re-run test 52C.
No
Replace
Ice tray
Hide quick links:
Advertisement
Table of Contents
