Table of Contents
Advertisement
Ice Maker Left and Right Mold Switch Removal
To replace the left freeze, and right fill mold switches:
1.
Unplug unit from wall outlet. Remove the ice bin
housing.
2.
Disconnect the wire leads from the switch terminals.
3.
Extract the single mounting screw. Remove the
switch and replace with a new one.
(See Figure 6-78)
Bail Arm Ice Level Switch Removal
To replace the bail arm ice level switch:
1. Unplug unit from wall outlet. Remove the ice bin
housing.
2. Disconnect the wire leads from the switch terminals.
3. Extract the single mounting screw. Remove the
switch and replace with a new one. (See Figure
6-78)
Ice Maker Drive Motor Removal
To replace the drive motor:
1. Unplug unit from wall outlet. Remove the ice bin
housing.
2. Disconnect the wire harness from drive motor.
2. Extract the two screws securing the drive motor to
the gear box. (See Figure 6-79)
3. Slide the motor straight back off the shaft.
Install the new motor using caution to line the gear on
the shaft up with the gear in the motor.
NOTE: To prevent damage to the gear box assembly
never move the ice mold by hand with out first removing
the motor.
Ice Maker Gear Box Removal
To replace the gear box:
1. Unplug unit from wall outlet. Remove the ice bin
housing.
2. Remove the bail arm switch and the drive motor.
3. Slide the gear box and bail arm off the ice mold
drive shaft. (See Figure 6-80)
On reassembly use caution to make sure the flat section
of the ice mold drive bar is lined with the correct
position on the inside of the gear box.
Component Teardown
Freeze Switch
Bail Arm Switch
Wire Harness
Connection
6-27
Fill Switch
Figure 6-78.
Drive Motor Screws
Figure 6-79.
Gear Box
Figure 6-80.
Hide quick links:
Advertisement
Table of Contents
