Ice Maker Housing; Fill Funnel; Fill Tube - Frigidaire LGUB2642LF2 Service Manual

Ice Maker Housing Removal
Disconnect power from the unit before performing this
procedure.
1. After completing the Ice Maker Removal Procedure,
remove the screws at the front of the Housing. Figure
6-56.
NOTE: One or both of the side screws may not be used.
2. With all the screws removed, pull the front end of the
housing body downward about an inch and feed the har-
nesses up through the square hole. Figure 6-57.
3. Pull the cover forward and out of the unit. The wiring
harness coming from the rear of the housing will slide
out the back of the housing. Figure 6-57.
Fill Funnel Removal and Replacement
Disconnect power from the unit before performing this
procedure.
The Fill Funnel is the black, plastic part that is inserted
into the top of the Ice Maker Housing. It serves to direct
the incoming water directly into the ice maker.
1. After completing the Ice Maker Housing Removal
procedure, remove the foam gasket covering the funnel.
Figure 6-58.
2. Pull the Funnel out of the housing.
3. To replace the Funnel, insert the funnel into the ob-
long hole in the top of the Housing. Be sure the long end
of the Funnel is oriented toward the rear of the housing.
IMPORTANT: The slotted opening in the funnel must
not be squeezed or deformed in any way.
4. Place a new gasket over the Funnel. The gasket must
be centered over the funnel so the opening of the funnel
is not obstructed.
Fill Tube Removal and Replacement
Disconnect power from the unit before performing this
procedure.
The 1/4" green fill tube from the water valve is adapted
to a 5/16" green tube approximately two feet above the
valve on the back of the unit.
1. After completing the Ice Maker Housing Removal pro-
cedure, disconnect the larger green tube from the in-line
connector.
NOTE: There will likely be some water that will spill
from the green tube. Be prepared to collect or wipe.
2. Push the tube forward about an inch into the back,
top of the unit. The tube will now protrude into the fresh
food compartment far enough to be gripped. Figure
6-59.
3. From the front of the unit, pull the tube downward
and out of the unit.
Component Teardown
remove two (2) screws
6-19
Figure 6-56
feed this harness up through
the hole in the housing
this harness will
slide out the back
Figure 6-74
Figure 6-57
Figure 6-58
black grommet must be
positioned as shown to
prevent kinking of the
tube in the conduit
Figure 6-59