Interior Components; Deli Keeper And Crisper; Water Filter - Frigidaire LGUB2642LF2 Service Manual

Component Teardown

Interior Components

Half and Full Spill Safe™ Shelf Removal
The shelves have mounting brackets that attach to
slotted supports at the rear of each compartment.
To change the position of a shelf:
1. Before adjusting a shelf, remove all food.
2. Lift the front edge up and pull the shelf out.
(See Figure 6-29)
3. Replace by inserting the mounting bracket hooks
into the desired support slots.
4. Lower the shelf and lock into position.
Deli Keeper and Crisper Removal
Crisper drawers include a sliding control for adjusting the
humidity inside the crisper. This feature can extend the
life of certain fresh vegetables that keep longer in high
humidity.
To remove the crisper drawer:
1. Pull the drawer out until it stops.
2. Lift the front slightly and remove the drawer.
(See Figure 6-30)

Water Filter

The water fi lter is located at the top right side of the fresh
food compartment. (See Figure 6-31)
Replacing the Water Filter
In general, you should change the water fi lter every six
months to ensure the highest possible water quality. Water
Filter Status on the user interface prompts you to replace
the fi lter after a standard amount of water (200 gallons/757
liters for PureSource 3) has fl owed through the system.
If your refrigerator has not been used for a period of time
(during moving for example), change the fi lter before
reinstalling the refrigerator.
Ordering Replacement Filters
To order your replacement fi lters, please visit our online
store at www.frigidaire.com/store, by calling toll-free at 877-
808-4195, or by visiting the dealer where you purchased
your refrigerator. Frigidaire recommends that you order
extra fi lters when you fi rst install your refrigerator, and that
you replace your fi lters at least once every six months.
Here is the product number to request when ordering:
PureSource 3 TM Water Filter
Part #WF3CB
6-10
Figure 6-29.
Figure 6-30.
Figure 6-31.