Sea-doo GS5847 Operator's Manual page 89

GTX RFI and GSX RFI Models
Monitoring Beeper Coded Signals
CODED SIGNALS
2 short beeps (while
installing safety lanyard on
switch).
1 long beep (while
installing safety lanyard on
craft switch or when
pressing start/stop button).
4 short beeps.
A 2 seconds beep every 60
seconds intervals.
8 short beeps.
Continuously beeps.
Engine Will Not Start
OTHER OBSERVATION
Engine does not turn over.
Engine turns slowly.
Engine turns normally.
POSSIBLE CAUSE
• Confirms safety lanyard
signal operation.
• Safety lanyard on switch
for more than 10 minutes
without starting engine.
• Bad connection.
• Wrong safety lanyard.
• Defective safety lanyard.
• Salt water in safety lanyard
cap.
• Improper operation of
MPEM or defective wiring
harness.
• Discharged battery.
• No communication
between ECU and MPEM.
• Fuel tank level is low.
• Defective MPEM.
• Engine overheats.
POSSIBLE CAUSE
• Safety lanyard removed.
• Burnt fuse.
• Discharged battery.
• Battery connections,
corroded or loose.
• Water flooded engine.
• Discharged or weak battery.
• Fuel flooded engine.
• Fuel tank empty or water-
contaminated.
• Burnt fuel pump fuse
• Fouled/defective spark
plugs.
• Electrical problem.
www.SeaDooManuals.net
REMEDY
Engine can be started.
Remove and reinstall safety lanyard
on switch.
Reinstall safety lanyard cap correctly
over switch.
Use a safety lanyard that has been
programmed for the craft.
Use another programmed safety
lanyard.
Clean safety lanyard cap to remove
salt water.
Refer to an authorized dealer.
Refer to an authorized dealer.
Refer to an authorized dealer.
Refill.
Refer to an authorized dealer.
See ENGINE OVERHEATING.
REMEDY
Install cap over switch.
Check wiring then replace fuse.
Refer to an authorized dealer.
Refer to an authorized dealer.
Refer to Submerged Watercraft in
SPECIAL PROCEDURES.
Refer to an authorized dealer.
Refer to Flooded Engine in
SPECIAL PROCEDURES.
Refill. Siphon and fill with fresh fuel.
Check wiring then replace fuse.
Replace.
Refer to an authorized dealer.
87