Sea-doo GS5847 Operator's Manual page 60

F02E03Y
GTS MODEL
1. Fitting spigot
2. Coupler hose
3. Hose pincher
Attach other end of coupler hose to a
garden hose. Do not open water tap
yet.
All Models Except SPX and GTS
To flush engine, connect a garden
hose to connector located at the rear
of watercraft near the jet pump.
NOTE: A quick connect adapter can
be used (P/N 295 500 473). No hose
pincher is required to flush engine.
3
F07E01Y
TYPICAL
1. Hose adapter
2. Quick connect adapter (not mandatory)
3. Garden hose
NOTE: The quick connect adapter is
supplied with GSX RFI and GTX RFI
models.
58
2 3
1
2 1
www.SeaDooManuals.net
All Models
Start the engine then immediately
open the water tap.
WARNING
Do not touch any electrical parts
or jet pump area when engine is
running.
-
CAUTION
Never flush a hot engine. Always
start the engine before opening
the water tap. Open water tap im-
mediately after engine is started
to prevent overheating.
Run the engine about 3 minutes at a
fast idle around 3500 RPM.
Spray BOMBARDIER LUBE lubricant
into air intake silencer keeping engine
at fast idle.
1
F01F25Y
SPX, GS, GTS, GTI, GTX RFI AND GSX RFI
MODELS
1. Air intake silencer
2. Pull plug
3. Spray BOMBARDIER LUBE here
NOTE: Lubrication of engine should
be done for at least 1 minute. After ap-
proximately half a minute, close fuel
valve to run engine out of fuel while
lubricating.
2
3