Sea-doo GS5847 Operator's Manual page 42

MULTIFUNCTION GAUGE
OPERATION
DISPLAY PRIORITIES
The clock/compass function is the ba-
sic mode of the Info Center gauge.
Use the compass as a guide only.
Not to be used for navigation pur-
poses.
The chronometer, tachometer and
speedometer are the only other
modes that may be chosen to replace
the clock/compass mode.
If another mode is chosen, the clock/
compass mode will be displayed again
after 4 seconds.
The Info Center also features a red
warning LED which blinks whenever
one of the following circumstances
occur: engine overheating, low fuel,
low oil and low voltage.
For example, if the fuel level is low, the
LED and the message LOW FUEL will
blink.
As a self test, all LCD segments and
the LED will turn on for 3 seconds
each time the watercraft is started.
In the event of a warning message
such as low fuel, hi-temp, etc., the
message will blink and override all oth-
er display functions.
If more than one warning message oc-
curs, the messages will blink and re-
appear every 4 seconds.
SCROLLING FUNCTIONS
Press the MODE button until the de-
sired function is displayed on the Info
Center gauge.
RESET A FUNCTION
To reset a function such as the chro-
nometer, peak speed, distance, etc.,
press and hold the SET button for 2
seconds while in the appropriate mode.
40
LANGUAGE OPTION
While in the clock/compass mode,
press and hold the SET button for at
least 2 seconds. Language option will
be displayed.
Press the MODE button to scroll lan-
guage (English, French and Spanish).
Press the SET button to confirm the
desired language and return to the
clock/compass mode.
ENGLISH/METRIC OPTION
Press and hold both MODE and SET
buttons for at least 2 seconds. The
system will be automatically changed.
CHRONOMETER
While in the chronometer mode,
press the SET button to start and stop
the chronometer.
Press the SET button for 2 seconds to
reset the chronometer.
CLOCK ADJUSTMENT
While in the clock/compass mode,
press and hold the MODE and SET
buttons for 2 seconds.
Press the MODE button to adjust the
hours and the SET button to adjust the
minutes.
Press again on the MODE and SET
buttons to return to the normal mode
(or it will return to the normal mode af-
ter 10 seconds).
MAINTENANCE INFORMATION
When the watercraft is due for a main-
tenance inspection, the message
MAINT will blink.
To clear the warning message, press
the SET button for 2 seconds during
the message blinking.
www.SeaDooManuals.net