Sea-doo GS5847 Operator's Manual page 80

F02E05Y
TYPICAL
1. Engine drain hose
GSX RFI and GTX RFI Models
Disconnect the water supply hose
used to cool the magneto. It features
a quick connect fitting. Press both
tabs and pull fitting in order to discon-
nect hose.
This hose is located at the bottom of
the magneto cover beside the engine
support.
F07E05Y
1. Disconnect this hose
Water should flow out of the fitting
(magneto cooling circuit) and hose
(crankcase heat exchanger).
78
1
1
www.SeaDooManuals.net
1
F07E06Y
1. Make sure water flows out of fitting and
hose
Watercraft Rinsing
Thoroughly rinse the watercraft hull,
bilge, engine compartment, with
fresh water.
Propulsion System
Lubricant in jet pump reservoir should
be drained and reservoir cleaned. Re-
fill with SEA-DOO synthetic polyolest-
er oil (75W90 GL5 type C gear lube).
Refer to an authorized dealer for this
operation.
-
CAUTION
Use only SEA-DOO jet pump oil
or equivalent synthetic gear oil,
otherwise component service life
could be reduced. Do not mix oil
brands or types.
Grease lubrication point(s) of propul-
sion system as explained in MAINTE-
NANCE section.
Fuel System
SEA-DOO fuel stabilizer (or equiva-
lent), can be added in fuel tank to pre-
vent fuel deterioration and carburetor
gumming. Follow manufacturer's in-
structions for proper use.
1