Fill up fuel tank completely. Ensure there is no water inside fuel tank. SYSTEM FLUSHING NOTE: Sea-Doo Fuel Stabilizer (P/N 413 408 600) Flush exhaust cooling system with fresh or equivalent should be added in fuel tank to water to prevent salt, sand or dirt accumulation prevent fuel deterioration.
Page 29
Perform an antifreeze density test. WARNING At preseason preparation, ensure to perform For the coolant replacement procedure, refer a fuel pressure test and ensure there is to the appropriate SHOP MANUAL. no leak. Also run engine and check for CAUTION: Improper antifreeze mixture might leaks.
Page 30
Connect an extra piece of hose to the upper intercooler nipple and pour approximately 200 mL (6.76 oz U.S.) of antifreeze into the intercooler. Then pour approximately 300 mL (10.14 oz U.S.) of antifreeze into the upper Intercooler hose, toward the exhaust manifold. Reconnect the intercooler upper hose.
CAUTION: Never clean fiberglass and plastic parts with strong detergent, degreasing agent, paint thinner, acetone, etc. If the watercraft is to be stored outside, cover it with an opaque tarpaulin to prevent sun rays and grime from affecting the plastic components, watercraft finish as well as preventing dust accumulation.
Page 32
2008-10 October 16, 2008 Subject: Storage Procedure YEAR MODEL MODEL # SERIAL # 2008 This is just a quick reference to the storage pro- NOTICE Should any water be trapped inside SHOP MANUAL cedure. Refer to the appropriate fuel tank, severe internal damage will occur to for the complete storage procedure.
Page 33
Intercooler Protection Exhaust System Protection In areas where temperature may freeze, water 255 Models (X Packages) trapped in the exhaust system must be removed. It is important to expel any trapped water that may STORAGE PROCEDURE 2008 Refer to in the have accumulated from condensation in the exter- SHOP MANUAL nal intercooler.
Need help?
Do you have a question about the 4-TEC series 2008 and is the answer not in the manual?
Questions and answers