Konica Minolta FK-502 Service Manual page 52

FUNCTION PARAMETER SETTING
Parameter
Receive Signal
Detection Mode
Receive Signal
Detect Time
Network
BUSY TONE Detec-
Setting 1
tion
BUSY TONE Detec-
tion No. of Times
1300 Hz Detection
Dial Tone Detection
DC-LOOP Check
Network
min.RING OFF Time
Setting 2
Response Waiting
Time
Pause time
A. Detailed Explanation
a. Receive Signal Detection Mode
• Sets to "Time" when ringer can not be detected by the number.
b. BUSY TONE Detection and BUSY TONE Detection No. of Times
Toot
c. DC-LOOP Check
• Checks the DC loop current before dialing.
• When the current is zero, an error occurs. (T.80, an error code is not displayed.)
• You can change the setting to be compliant to standards in other countries. In Japan, set this parameter
to OFF.
3-16
Set Value
No. of Times / Time
0 to 15[sec]
(in steps of 1 sec)
ON / OFF
0 to 15
(Zero time equals to no
detection.)
ON / OFF
ON / OFF
ON / OFF
0 to 1000[ms]
(in steps of 100 ms)
35 to 115[sec]
(in steps of 5 seconds)
1 to 7[sec]
(in steps of 1 second)
Toot
1 2
FK-502 Service Manual Ver.1.0
Factory-shipped
Default Setting
No. of Times
6 [sec]
ON
The default setting
is different
depending on the
country.
OFF
OFF
OFF
0 [ms]
55[sec]
1[sec]
Toot Toot
3
When the number of tones is set
to three, judged to be busy here.
Reference
Yes
Yes
Yes
Yes
Yes
Yes
Yes