Konica Minolta FK-502 Service Manual page 49

FK-502 Service Manual Ver.1.0
A. Detailed Explanation
a. V17 EP TONE and V29 EP TONE
• Whether the EP tone (Echo Protect: 2100Hz) is added to the top of the training signal.
b. V17 Selection Mode "-"
• V.34 is not used when a dash (-) is added at the top of dial number.
c. ANSam Send Time
• Determines the ANSam output time of V.8 procedure signal.
• Normally you do not need to change.
d. Foreign Communication Function
• V.34, V.17 and V.29 International communication mode speed
• The mode using the number of DIS waiting is turned ON.
• The international communication mode setting at the time of transmission becomes effective.
e. T1
• T1 timer (T.30 standard)
• Response waiting timer (55sec)
f. DELAY TIMER
CED
g. EOL-EOL
EOL
h. CFR-PIXWAIT
• Sets the waiting time from CFR is sent to the image signals are received. Radio fax on boats occasionally
requires more than 6 sec.
i. EOM-PIXWAIT
Some fax machines sends PIX without returning to Phase B in spite of EDM. Waiting time to receive PIX
j.
before sending DIS when EOM is used.
k. JM WAIT
• Time to continue outputting CM until receiving JM. Some machines cannot receive CM with simulta-
neously sending ANSam.
l. Coding Ability
• Effective to both sending and reception.
:Calling: designate by the response waiting timer
Called: Starts after DIS is output.
The waiting time until DCS is received.
: Calling : Starts after dialing. Until CED is received.
DCS
DIS
1 line data
EOL
TCF PIX PMC
PMC : Post Massage Command
1 line data
FUNCTION PARAMETER SETTING
3-13