Tadiran Telecom Emerald ICE User Manual page 30

2-20
Emerald ICE Standard Telephone User Guide
Setup
1. Program a Feature/DSS button for Voice Announce as described in Section
2.12 if you have not programmed it already. Use
applicable Feature Code.
2. While your extension is idle, press
tone.
p98
PGM
3. Press
The LED for the Voice Announce Feature/DSS button will illuminate as
described in Table 2‐1.
Receiving a Call in VA-HF Mode
When your extension is idle, you will be alerted of intercom calls by one tone
burst. The voice connection is then established immediately and you can respond
to the calling extension via the speakerphone.
Receiving a Call in VA-Privacy Mode
1. When your extension is idle, you will be alerted of an intercom call by one
tone burst. The voice connection is then established immediately with the
Mute function activated at your extension. You hear the calling extension
voice announcement over the speaker, but the microphone in your
telephone is disabled.
2. You can:
a. Lift the handset for privacy.
m
b. Press the
caller using the speakerphone.
Receiving a Call in Tone Mode
1. When your extension is idle, you will be alerted of an intercom call by a
double‐burst tone which is repeated until you respond or until the call
follows a Call Forward route.
2. You can:
a. Lift the handset for privacy.
S
b. Press the
caller using the speakerphone.
Operational Notes
• During Tone Ring, the red LED associated with the
The LED associated to that Voice Announce button will indicate the current
mode selection as shown in Table 2‐1.
p98
PGM
again to advance through each of the available modes.
button to deactivate the Mute feature and speak with the
button to activate the speakerphone and speak with the
p98
PGM
as the
. You hear a confirmation
S
button will flash.