7.3 Wiring the Signal and Control I/O
Terminal
Number
1
RS-232 Transmit
2
RS-232 Receive
3
RS-232 Signal/Regulator
Common
4-9
Encoder Wiring
Wiring the Regulator Board Terminal Strip
Wire the drive's signal and control I/O to the terminal strip as shown in table 7.8.
Table 7.9 – Wiring Signal and Control I/O to the Terminal Strip
Description
Wiring RS-232 Signals
Wiring Encoder Inputs
Parameters/Wiring Connections
Note that RS-232 communication between the drive and a
personal computer requires the use of the Control and
Configuration software. Refer to instruction manual D2-3348
for more information.
These terminals should only be used when the RS-232 port
(J8) or an Operator Interface Module (OIM) are not being
used, as all three devices use the same transmit/receive
lines.
See section 7.2.
7-9