Reliance electric GV3000 Instructions Manual page 4

Chapter 4
Chapter 5
Chapter 6
Chapter 7
Chapter 8
Chapter 9
Appendix A
Appendix B
Appendix C
Appendix D
Index
II
Mounting the Drive, Grounding, and Finding Wire Routing Locations
4.1 Mounting the Drive ...........................................................................................4-1
4.1.1 Verifying the Drive's Watts Loss Rating.................................................4-1
4.2 Determining Input, Motor Output, Ground, and Control Wire Routing
for the Drive......................................................................................................4-1
4.2.1 Replacing Conduit Plugs .......................................................................4-2
4.3 Grounding the Drive .........................................................................................4-2
Installing Input Power Wiring
5.1 Installing Transformers and Reactors (Optional) .............................................5-1
5.2 Installing Fuses for Branch Circuit Protection ..................................................5-2
5.3 Installing a Required External/Separate Input Disconnect...............................5-2
5.4 Installing Power Wiring from the AC Input Line to the Drive's Power
Terminals .........................................................................................................5-5
5.5 Installing Power Wiring from an External DC Bus to the Drive's Internal
DC Bus Terminals ............................................................................................5-6
5.6 Changing Blower Transformer Taps ................................................................5-6
Installing Output Power Wiring
6.1 Installing Output Contactors (Optional) ............................................................6-1
6.2 Installing Mechanical Motor Overload Protection (Optional) ............................6-1
6.3 Installing Output Wiring from the Drive Output Terminals to the Motor............6-1
Wiring the Regulator Board Terminal Strip
7.1 Stopping the Drive............................................................................................7-6
7.1.1 Compliance with Machinery Safety Standard EN 60204-1:1992...........7-6
7.2 Wiring the Encoder Feedback Device (FVC Regulation Only).........................7-7
7.3 Wiring the Signal and Control I/O.....................................................................7-9
Completing the Installation
8.1 Checking the Installation ..................................................................................8-1
8.2 Installing the Cover for NEMA 4X/12 Drives ....................................................8-2
8.3 Powering Up After Installation Is Complete......................................................8-2
Troubleshooting the Drive
9.1 Test Equipment Needed To Troubleshoot .......................................................9-1
9.2 Drive Alarms and Faults...................................................................................9-1
9.3 Verifying That DC Bus Capacitors Are Discharged..........................................9-1
9.4 Checking Out the Drive with Input Power Off...................................................9-8
9.5 Replacement Parts.........................................................................................9-12
Technical Specifications........................................................................................... A-1
Compliance with Machinery Safety Standard EN 60204-1:1992 ............................. B-1
Compliance with Electromagnetic Compatibility Standards ..................................... C-1
200-400 HP GV3000/SE System Wiring Diagrams ................................................. D-1
...........................................................................................................................Index-1
GV3000/SE AC Drive Hardware Reference, Version 6.06