Figure 4.7 - Wire Routing Locations For 200-400 Hp Drives - Reliance electric GV3000 Instructions Manual

PULL SHIELD TABS IN AND ROTATE SHIELD OUT
CONNECT USING 350MCM TWO HOLE TERMINAL LUGS
GND
DC- DC+
BM
ALLOW 6 INCH RADIUS SERVICE LOOP
WITH INTERCONNECTION WIRING FROM
J1 CONNECTOR ON REGULATOR BOARD.
Mounting the Drive, Grounding, and Finding Wire Routing Locations
GROUND, A-C INPUT AND A-C OUTPUT TERMINALS
POWER CONNECTIONS
TORQUE TO 325IN-LBS
U V W R S T
-DC +DC VOLTMETER TEST POINTS
DANGER !
DANGER
1FU
D-C BUS CAPACITORS RETAIN HAZARDOUS VOLTAGES
CLASS CC
AFTER INPUT POWER HAS BEEN DISCONNECTED.
LITTLEFUSE
WAIT FIVE (5) MINUTES FOR THE D-C BUS
TYPE MR
CAPACITORS TO DISCHARGE AND THEN CHECK THE
VOLTAGE WITH A VOLTMETER THROUGH THE ACCESS OR EQUIV.
2A
SLOTS SHOWN ABOVE. VOLTAGE MUST BE 50 VOLTS
OR LESS PRIOR TO SERVICING.
2FU
CONTROL BOARD WIRING TRAY TO
Figure 4.7 – Wire Routing Locations for 200-400 HP Drives
SIGNALS (VIA WIRING TRAY)
VIEW FROM TOP
(with Cover Removed)
GND
DC- DC+ U/T1
SIGNALS (VIA WIRING TRAY)
WIRING HARNESS 807300-138R
V/T2 W/T3 R/L1 S/L2 T/L3
4-9