Option Board Connector; Operator Interface Module Connector; Keypad/Display; Figure 2.15 - Keypad/Display - Reliance electric GV3000 Instructions Manual

2.8.4 Option Board Connector

2.8.5 Operator Interface Module Connector

2.8.6 Keypad/Display

About the Drive
The flat-ribbon cable connector (J3) on the left side of the Regulator board is a parallel
bus connection port that provides a means of attaching optional boards such as the
DeviceNet Option board, the RMI board, the AutoMax Network Option board, or
similar boards to the GV3000/SE drive. See figures 2.9, 2.10, and 2.11. The option
board is mounted below the Regulator board inside the drive. Refer to the appropriate
board instruction manual for more information. Refer to section 2.9 of this manual for
more information on optional drive kits.
Flat-ribbon connector J7 provides a means of attaching the optional Operator
Interface Module (OIM). The OIM is available for use as a remote keypad for the drive.
Refer to the Operator Interface Module manual (D2-3342) for more information.
The front panel keypad/display is used to program and operate the drive. See figure
2.15. The four-character display is used to indicate drive parameters, parameter
values, and error codes. The fourteen single LEDs indicate drive status and operating
mode, as well as identify drive outputs whose values are displayed on the
four-character display.
Refer to the GV3000/SE Software Start-Up and Reference manual for more
information about the keypad/display.
Monitor Mode
LEDs
Password LED
STOP/RESET
Key
Drive Status LEDs
Display
!
A U T O
S P E E D R U N N I N G
V O L T S
R E M O T E
J O G
A M P S
H z
A U T O PROGRAM
K w F O R W A R D
T O R Q U E R E V E R S E
Password P R O G R A M
S T O P
S T A R T
R E S E T
START Key
Figure 2.15 – Keypad/Display
Keypad
Forward
Reverse
M A N
R U N
J O G
E N T E R
RELIANCE
ELECTRIC
2-19