Sole Diesel MINI 17 Instruction Manual page 28

Electrical system
DAILY CHECKING BEFORE USE OF THE ENGINE
Check oil level in the engine and gearbox. Filling. Filling is
not required if level is near to the rod upper line.
Check fuel level and open fuel delivery cock.
Open the water access cock.
Check indicators. After commisioning check oil pressure,
water temperature and battery charge. The three lamps
must be switched off and the alarm must not be sounded..
Check cooling water is flowing and if some failure is
detected in the exhaust gases, noise and vibrations.
Check cooling water level.
EVERY 200 OPERATING HOURS
Change oil engine a.
Change oil filter.
Water filter cleaning.
Check battery level.
EVERY 800 OPERATING HOURS
Check the starting motor pinion and the flywheel toothed
crown.
Change alternator belt.
Check the compression pressure of each cylinder.
Injector checking.
Inspection concept
Every instrument
Incandescent spark plug
Alternator and starting motor
Alternator belt and tension
Battery level
03917700.ENG
Daily 1ª 50
hour
Cleaning
Change
AFTER THE FIRST 50 OPERATING HOURS
Change oil engine, gearbox and cover fuel supply pump.
Change oil filter.
Fuel decanting filter drainage ( if equipped )
Control and eventual adjustment of the alternator belt.
Overhaul of the propeller shaft and positioning screw
tightening torque.
Clean water filter for impurities.
EVERY 400 OPERATING HOURS
Check the tightening torque of the engine positioning,
propeller shaft screw and gas-oil piping nipples.
Adjust valve clearance.
Check incandescent spark plugs in case they might fused
or it there is two connections.
Change air filter
Inspect injection pump.
Check condition of sea water pump impeller and its
eventual replacement.
Check the alternator and starter.
Control and eventual adjustment of the alternator belt.
Change fuel filter.
Decanting filter component change (if equipped)
Gearbox oil change.
Change the refrigeration anti-freeze liquid.
Clean the fuel tank.
ENG - 26
rev. 0
INTERVALOS
Cada 200 Cada 400 Cada 800
hour hour
Inspection, adjustment or filling
Drainage
EVERY 2 OPERATING YEARS
Every 2
hour years