Safety - Taylor QS11 Original Operating Instructions

Section 3
We, at Taylor Company, are deeply concerned about
the safety of the operator when he or she comes in
contact with the grill and its parts. Taylor has gone to
extreme efforts to design and manufacture built-in
safety features to protect both you and the service
technician. As an example, warning labels have been
attached to the grill to further point out safety
precautions to the operator.
IMPORTANT - - Failure to adhere to the
following safety precautions may result in severe
personal injury or death. Failure to comply with
these warnings may damage the machine and its
components. Component damage will result in
part replacement expense and service repair
expense.
To Operate Safely:
DO NOT operate the grill without reading
this Operator's Manual. This manual should be kept in
a safe place for future reference.
This appliance is to be used only by trained
personnel. It is not intended for use by children or
people with reduced physical, sensory, or mental
capabilities, or lack of experience and knowledge,
unless given supervision or instruction concerning the
use of the appliance by a person responsible for their
safety. Children should be supervised to ensure that
they do not play with the appliance.
This equipment is provided with a grounding lug
that is to be properly attached to the rear of the frame
by the authorized installer. The installation location is
marked by the equipotential bonding symbol (5021 of
IEC 60417--1) on the removable panel and the frame.
130304

Safety

DO NOT operate the grill unless it is
S
properly grounded.
DO NOT operate the grill unless all service
S
panels are restrained with screws.
DO NOT use the cord if it is frayed.
S
All repairs must be performed by an
S
authorized Taylor service technician.
DO NOT attempt any repairs unless the
S
power supply to the grill has been
disconnected.
For Cord Connected Units: Only Taylor
S
authorized service technicians or licensed
electricians may install a plug or
replacement cord on these units.
Stationary appliances which are not
S
equipped with a power cord and a plug or
other device to disconnect the appliance
from the power source must have an
all--pole disconnecting device with a contact
gap of at least 3 mm installed in the external
installation.
Appliances that are permanently connected
S
to fixed wiring and for which leakage
currents may exceed 10 mA, particularly
when disconnected, not used for long
periods, or during initial installation, shall
have protective devices such as a GFI to
protect against the leakage of current and
be installed by authorized personnel to the
local codes.
Supply cords used with this unit shall be
S
oil-resistant, sheathed, flexible cable, not
lighter than ordinary polychloroprene or
other equivalent synthetic elastomer-
sheathed cord (Code designation 60245 IEC
57) installed with the proper cord anchorage
to relieve conductors from strain, including
twisting, at the terminals and protect the
insulation of the conductors from abrasion.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent, or similarly qualified person, in order
to avoid a hazard.
Failure to follow these instructions may result in
electrocution. Contact your local Taylor Distributor for
authorized service.
8
Safety
Models QS11 & QS23