Taylor QS11 Original Operating Instructions page 13

Grill clearance must be maintained at least
3" (76 mm) from all combustible materials
(0" to non--combustible materials).
Failure to comply could result in a fire hazard.
All grills require 3" (76 mm) of air clearance in the rear.
Failure to comply will hinder grill performance.
DO NOT use a water jet to clean or rinse the
grill. Failure to follow this instruction may result in the
following:
serious electrical shock
S
burns from hot steam
S
liquid collecting inside the grill and
S
destroying electrical components.
DO NOT prepare or remove product without
S
proper equipment.
DO NOT allow untrained personnel to
S
operate this grill.
USE EXTREME CAUTION when cleaning
S
the grill.
Failure to follow these instructions may result in severe
burns from high temperatures.
Models QS11 & QS23
This grill must be placed on a level surface.
Failure to comply may result in personal injury or
equipment damage.
Access to the service area of the unit is
restricted to persons having knowledge and practical
experience with the appliance, in particular as far as
safety and hygiene are concerned.
Cleaning and sanitizing schedules are
governed by your Federal, State, or local regulatory
agencies and must be followed accordingly. Please
refer to the cleaning section of this manual for the
proper procedure to clean this unit.
CAUTION: DO NOT attempt to use the grill
during a power outage. Grills require electrical
power for operation. In the event of a prolonged power
outage, place the unit in the "OFF" position.
DO NOT slide the grill with the legs attached.
Failure to follow this instruction may damage the grill.
NOISE LEVEL: Airborne noise emission does not
exceed 70 dB(A) when measured at a distance of 1.0
meter from the surface of the machine and at a height
of 1.6 meters from the floor.
9
130304
Safety