Taylor QS11 Original Operating Instructions page 9

Step 4
For each cook surface requiring adjustment, place the
four gap blocks on the cook surface, approximately 2"
(51 mm) in from each corner. (Figure 5)
Figure 5
Step 5
Lower the cook surface assembly. Loosen and slowly
move the T-handle to the left until the gap
indicator/pointer is at #8 on the gap indicator plate, and
tighten the T-handle.
Figure 6
Models QS11 & QS23
Step 6
Wearing proper protection, carefully attempt to raise
the gap slide to evaluate which gap pin is in need of
adjustment.
With the gap slide raised, slowly turn the gap pin
needing adjustment until it makes contact with the
cook surface. Note: Do not use force to adjust the pins.
Repeat these steps for both gap slides.
Step 7
Raise the upper cook surface and remove the four gap
blocks.
5
Figure 7
Figure 8
To the Installer